LifeSize Multipoint-12, Installation Manual

Page: 26 / 49

18 LifeSize Multipoint Installation Guide
LifeSize Multipoint Unit Initial Configuration
2
When the message “Press any key to start configuration”
appears on the screen, press any key within 6 seconds.
The network configuration
Main menu appears.
3
At the prompt, enter A to display the Advanced
Configuration menu and press Enter .
The Advanced Configuration menu appears.
4
At the prompt, enter 3 to select “Change LAN port Settings”
and press Enter .
5
At the prompt, enter the number or letter for one of the
following:
1 - 10Mbps Half Duplex
2 - 100Mbps Half Duplex
3 - 10Mbps Full Duplex
4 - 100Mbps Full Duplex
5 - Auto
Q - Quit
Enter this value to retain the current setting. The default setting
is Auto.
6
Press Enter .
The network configuration Main menu appears.
7
At the Network Configuration menu, do one of the following:
Enter the letter for the set of parameters that you want
to configure.
Enter
Q to save your changes and allow the device to
complete the boot process.
C
ONNECTING THE
L
IFE
S
IZE
M
ULTIPOINT
U
NIT TO THE
LAN
This section describes how to connect the LifeSize Multipoint unit to the Local
Area Network (LAN).
Procedure
1
Connect the supplied LAN cable from your network switch to
the 10/100BaseT Ethernet port on the front panel of the