Lifesize Icon Installation Guide
7
6.
Icon 600:
Insert the cord from the power adapter into the power outlet marked
on the back of the
codec. Insert one end of the power cord into the power adapter and the opposite end into a power
outlet on the wall.
Icon 800:
Insert the power cord into the back of the system. Insert the opposite end of the power cord
into a grounded power outlet. Apply power using the power switch on the back of the system. Refer to
Power and Reboot for Icon 800
.
NOTE
Verify that the cable inserted into the back of the codec is the larger power
adapter and not the smaller camera cable.
The Lifesize system starts and illuminates an LED on the front of the codec. When the video system
completes the startup process, an initial configuration wizard directs you to configure the language,
network settings, and time zone. You can also connect your Icon to the LifeSize Cloud service.
If no IP address is assigned to your system, configure the IP address using a directly connected
Ethernet cable between your computer and the system. Read more at
Using a Directly Connected
Ethernet Cable
.
WARNING
To avoid damaging the system, do not disturb or disconnect any of the
connected devices while the system is starting.
7.
Perform additional configuration tasks from a web browser: enter the video system’s IP address, and
log in with administrator credentials. The default username and password are
admin
.
Lifesize recommends changing your password at this time.
For problems with installation, refer to
Troubleshooting
.
Configuring Your System
Refer to the
Lifesize Icon Video System Guide
and the browser-based online help for additional
configuration steps and if your environment uses any of the following:
•
Network Address Translation (NAT)
•
firewall
•
automatic configuration of Lifesize devices
•
H.323 gatekeepers
•
SIP registrars
•
other network security systems
