LifeSize Gateway-PRI, User Manual

Page: 116 / 196

108 LifeSize Gateway User Guide
Configuring Port Settings
6
(Gateway-PRIs only—optional) Select the Strip Local Area
Code check box if you want the LifeSize Gateway to strip
local area codes for outbound calls to the ISDN network.
Note
The type of line connected to this PRI port appears in the Physical
standard field.
C
ONFIGURING
P
ORT
P
HYSICAL
I
NTERFACE
S
ETTINGS
This section describes the available configuration options for LifeSize Gateway
ports.
PRI Ports
Serial Ports
PRI P
ORTS
Note This section applies only to Gateway-PRI.
In the Physical Interface section of the PRI Port tabs, you can configure the
physical line properties of the specified PRI port.
Procedure
1 In the LifeSize Gateway interface, on the sidebar, click
Gateway (if not already selected).
2
Click the applicable PRI Port tab.
3 Click the Physical Interface button.
4
Select the Same as Port check box if you want to duplicate
physical interface settings from another PRI port that you
choose from the field. When selected, you cannot modify any
settings in this section. This option is not available in LifeSize
Gateways that support only one PRI port.
5 In the Interface field, choose the line interface: T1 or E1 .
6
In the Country field, choose the nation where the ISDN
service is installed.
7 In the Signaling protocol field, choose the signaling protocol
used to set up and tear down the calls through the signaling (D)
channel. Depending on the interface used, different signaling
protocols are available.