INSTALL THE BASEFRAME END CAPS
You will need:
treadmill baseframe
(A)
, 2 end caps
(B)
,
hex key
(N)
Endurance Training Collection
11
SAFE PLACEMENT OF YOUR PAWRUNNER TREADMILL
• Use the treadmill in a well-ventilated room and avoid using in rooms that
are too warm to prevent heat exhaustion and heat stroke.
• Set up the treadmill with at least 7 feet of clearance from walls and
furniture at the back and at least 4 feet of clearance at the front and
sides of the treadmill. Never place the treadmill with the back of the
running belt against a wall, door, stairs, or any other obstruction.
• Do not use outdoors or in high-moisture, high-temperature, or high-dust
environments.
• Only operate and store the PawRunner on a flat, non-slip floor.
• Ensure the running deck is level to the ground. If the deck is positioned on
an uneven surface, it could cause damage to the electrical system.
• If setting up in a carpeted room, check underneath the treadmill to ensure
clearance between the carpet and the running deck. If there is not enough
clearance, or you’re not sure, place a mat or rug under the PawRunner.
Ensure the mat or rug is at least 55” × 30” and will not slip during use.
• Sometimes after an extended amount of use, you will find a fine black
dust under the treadmill. This is normal wear and does not mean there is
anything wrong with the treadmill. The dust can be easily vacuumed up. If
you wish to prevent the dust from getting on your flooring or carpet, place
a mat or rug under the treadmill.
10
PawRunner User Manual Lifepro
1. Lay the treadmill baseframe
(A)
on a flat, non-slip floor.
2. Locate the four screws on the outside-rear of the treadmill baseframe.
There are two screws above each of the two non-skid feet.
3. Use the hex key
(N)
to remove the two screws on the left side of the
baseframe.
4. Align one plastic end cap
(B)
with the two screw holes.
5. Re-insert the two screws to secure the end cap.
6. Repeat 2–5 above to install the second end cap to the right side of the
baseframe.
7. Use the hex key
(N)
to fully tighten the screws.
A
B
B
TOOLS & HARDWARE
(N)
1
