12
AcuCare Tilt User Manual Lifepro
Re Fitness Collection
13
USING THE SWING FUNCTION
The AcuCare Tilt has a swing function which is on by default for all three
massage modes. When the swing function is on, the body of the massager
will swing forward and backward during your massage. Use the remote
control to turn on/off the swing function:
• To turn off the swing function, press the
Suspend button
.
• To turn on the swing function again, press the
Angle button
.
• To return the body of the massager to its fully-upright position, press
the
Reset button
.
CHOOSING A MASSAGE MODE
The swing function is on by default for all three massage modes. The
default air pressure intensity and heat for all modes is medium. You may
adjust the heat or intensity level at any time. You may change the mode at
any time. The default massage mode is Mode A.
• Mode A:
Uses the massage roller and the air pressure massage.
• Mode B:
Uses air pressure only. Air pressure increases, holds, then
releases.
• Mode C:
Uses massage roller only. Roller moves forward and backward.
CLEANING THE REMOVABLE CLOTH COVERS
1. Unzip the two removable covers and remove them from the foot
massage chambers.
2. Soak a soft, clean cloth or towel in soapy water. Completely wring the
cloth out.
3. Use the cloth to gently clean the removable covers.
4. Allow the removable covers to completely dry.
5. Tuck the covers back into the foot massage chambers and zip each
cover into place.
CREATING A MASSAGE WITH YOUR ACUCARE TILT
1. Insert clean and dry feet into the foot massage chambers.
2. Press the
ON/OFF button
on the remote control or the
Power/Mode
button
on the control panel to turn on the AcuCare Tilt. The default
massage program will begin automatically: Mode A is selected, along
with medium heat, and medium air pressure intensity.
3. To change the default massage mode, press the
Mode button
to toggle
through the three modes: Mode A (1 LED lit), Mode B, (2 LEDs lit), and
Mode C (3 LEDs lit).
4. To change the default air pressure intensity, press the
Intensity button
to toggle through the four air pressure intensity settings: low (1 LED),
medium (2 LEDs), high (3 LEDs), and off (no LEDs lit).
5. To change the default heat setting, press the
Heat button
to toggle
through the four heat settings: low heat (1 LED lit), medium heat (2
LEDs lit), high heat (3 LEDs lit), and no heat (no LEDs lit).
6. Press the
Power button
to stop the massage at any time.
7. The unit will automatically shut down after 15 minutes of use. Press
the Power button again if you wish to continue using the device.
8. Always power off, flip the Power switch to the OFF position, and unplug
the AcuCare Tilt after each use.
NOTE:
The massage time is 15 minutes and cannot be adjusted.