background image

Power indicator is on and not working

Low air volume

Power light does not work

No cool air when the power indicator is on

Solution

Fault

Check whether the buttons are on

In addition to the possibility of this machine, it is 

necessary to check the indoor power supply

Check whether the air inlet is blocked. If there is 

any blocks, remove it

FAULT AND SOLUTION

- 13 -

- 14 -

STORAGE & MAINTAINENCE GUIDELINES

WARNING: Always switch OFF the Air Cooler and unplug it from the electrical source 
before cleaning or maintenance. Cleaning At least once a week, drain the water tank 
completely and refill with fresh water. Doing this will greatly reduce mineral deposits and 
help to extend the life of the water pad. End of Season Storage If the Air Cooler will not 
be used for a long time:

Make sure all parts are dry by running the Fan Only mode for about 30 minutes before 
storing (time depends on ambient humidity conditions). Switch OFF the Air Cooler and 
unplug from the power supply. Empty/drain all the water from the tank. Clean the water 
tank with a damp cloth to wipe away any dust or mineral deposits. Remove the water pad 
from the Air Cooler and rinse under fresh water to remove dust and dirty ( Do not rub the 
mesh with your hand to avoid deformation and deformation of the net, affecting the wind), 
and put it back into the fuselage. See Figure A below .  To protect the unit from dust and 
scratches, cover with a clean cloth or plastic bag before storing. Coil the power cord and 
store it away from the floor to protect it.

CLEANING & DRAINING THE WATER TANK

If the cooler will not be used for a long period of time, please refer to the STORAGE & 
MAINTENANCEGUIDELINES located in the separate Safety & Maintenance Guide.

WARNING:

Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket. 
unscrew the water pump knob, pull out the water tank, clean the water tank and put it 
back, and screw the water pump knob to the water pump. See Figure B below

Refill the water tank with clean water and drain it completely. Refill the water tank with 
clean water, up to the maximum level. Use a damp cloth to remove the dirt and dust from 
the surface of the unit. Never use corrosive elements or chemicals to clean this product. 
When the product is not in use, store the unit in a dry place out of direct sunlight.

WRANTY

After-sales Service Letter of Commitment:  
All products purchased in our company are guaranteed to keep in good repair for 1 year. 
If quality problems happen in guarantee period, our company will maintain for free or 
provide replacement. Additionally, our company provides technical support and fittings for 
life. After-sales service isn't restricted by time and hear feedback idea of users and deal 
with them in time. If you are caught in some problems when using our products, welcome 
to contact us at any time.

[email protected]

[email protected]

Check whether the water tank is well filled, and 

the water level shall not exceed the max water 

level or be lower than the min water level.

Summary of Contents for BLF-T09









Reviews: