15
Depositng
The treadmill should be deposited indoor in case of being damp. Water
can’t be spattered and nothing can be laid and inserted on the treadmill.
Please keep the air a little humid in winter. And please void the big static
electricity, it may disturb the operation of meters or even damage them.
ANALYZING AND ELIMINATING MALFUNCTION
14
RUNNING BOARD LUBRICATION
GUIDES FOR MALFUNCTION
The treadmill is equipped with lubricated running board, which needs
constant maintenance. The friction between running board and running
belt has a great effect on the treadmills’ e life. So please lubricate your
machine termly. The steps are as follows:
a)
Cut off the power
b)
Wipe out the dust between running board and running belt with a clean
cloth.
c)
Daubing the Silicon oil on the running board and running belt equably.
d)
While adding lubrication oil, please keep your clothes away from the
machine for avoiding the injury.
CLEANING
a)
Please power off and pull the plug cap out before cleaning.
b)
Wipe out the dust stuck on the surface and running board frequently.
c)
Please clean the surface of frame and running belt with a soft cloth
dipped with suds, don’t use things like eradicator and naphtha.(After
cleaning, please dry it for use).
d)
Please take the protecting cover off every two month, use vacuum
dust-collector to suck the dust remaining inside of the protecting
cover.(The dust will make the components of circuitry board short circuit).
CAUTIONS, FOLDING, DEPOSITING
Cautions
Please make sure that the plug cap has been pulled out before cleaning or
maintenance
.
ITEM
1
2
3
4
5
6
7
MALFUNCTION
Treadmill can’t be started.
Meter can’t display
Heart rate can’t be displaye
Incline doesn’t work
Running belt runs faster or
slower than what has been
displayed
Running belt slips
Running belt is deflected
REASONS
The safe key isn’t in the right
position
The electrical switch is placed
to “0”
creepage switch is not right
The meter control line and
control panel are unconnected
The pole of heart rate sensor is
not wet enough.
Disturbed by electromagnetis
The motor wire is not well
connected
Unadjusted
Running belt is not tight
enough
The running belt is unadjusted
SOLUTION
Put the safe key in the right
position
Turn the electrical switch to “1”
Replace creepage switch
Pull the bolt out and open the
motor cover and reconnect it
Turn on the meter and
reconnect
Wet the pole with water or
liquor for hard contact lenses
Stay away from
electromagnetism
Open the motor cover and
reconnect it
Readjust it
Please read point 3.3
Adjustment steps for tightening
running belt for reference
Please read point 3.4 The steps
for adjusting the deflected
running belt for reference