STEP 12:
• Insert the two GUIDE RODS (38) (found in SHROUD KIT box) into the base of the TOWER (1) as shown in FIGURE 12. Lubricate
the GUIDE RODS (38) with a slicon or teflon spray that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (29) down over the GUIDE RODS (38). See FIGURE 12
• Using
EXTREME CARE
place twenty 10 LB. WEIGHT PLATES (39) over the GUIDE RODS (38) as shown in FIGURE 12.
(NOTE:
If HEAVY WEIGHT OPTION is being used, slide ten 15LB. WEIGHT PLATES (40) over the GUIDE RODS (38) first, then
slide ten 10 LB. WEIGHT PLATES (39) over the GUIDE RODS.)
• Carefully Slide the HEAD PLATE (11) down over the GUIDE RODS (38) onto the weight stack as shown in FIGURE 12.
• Slide one WEIGHT STACK SELECTOR PIN (28) over the shaft on the HEAD PLATE (11) as shown in FIGURE 12.
FIGURE 12
11
• Slide two GUIDE ROD BUSHINGS (33) over each GUIDE ROD(38).
• Slide two 1” SHAFT COLLARS (31) over each GUIDE ROD (38) as shown in FIGURE 12.
• Place the GUIDE ROD SUPPORT (5) over the GUIDE RODS (38) as shown in FIGURE 12.
29
39
38
11
28
31
33
5
1
39
40
HEAVY WEIGHT
OPTION
1A
