4. Check that the tank basin is clean. Replace the water tank gently on the unit base.
Water from the tank will flow down and fill the white base.
5. Plug the unit into a power outlet and turn it on by turning the operation button.
The
green indicator light will turn on and the unit will start working. When there is no water in
the water tank the indicator light will glow red.
(Do not operate the unit when the tank is
empty).
6. Adjust mist intensity by turning the mist intensity control button.
7. To turn the nightlight ON/OFF press the nightlight switch.
8. Water on the white unit base is a normal and regular process.
5. Troubleshooting:
Possible Solutions
Possible causes
Problem
Plug unit into a power outlet.
Turn on by rotating the
operation button.
The unit is not plugged in
to a power outlet
The operation indicator light
does not turn on, and the
unit is not working
Fill the water tank with water.
No water in the tank.
The operation indicator light
is on, but mist is not
released from the unit. Mist
flow is not visible.
Turn on the operation button.
The operation button was
not turned enough.
Remove the water tank from
the base.
Open the cap and let
the tank be refreshed for 12
hours.
New unit.
Strange mist odor.
Clean the water tank
according to the manual's
instructions, and fill it with
fresh, clean water.
Water in the tank is dirty
or has been standing for
a long time.
Turn the unit off and
disconnect it from the power
outlet.
Empty water from the
water basin at the unit's base.
Too much water in the
water basin.
The operation indicator light
is on, but the unit does not
work.
Regulate the operation button.
The operating button is at
the lowest level.
Mist intensity is low.
Turn the unit off and
disconnect it from the power
outlet.
Clean the water basin
area.
Clean the ceramic filter.
Clean the water tank and fill it
with fresh clean water
according to the manual's
instructions.
The water basin at the
unit's base is dirty or
water has been standing
for a long time.
Fill the water tank with water.
No water in the water
tank.
The unit is noisy.
Place the unit on a firm
surface.
Unit is on an unstable
surface.
Immerse the nozzle in water
for a few minutes then
reattach it to the water tank.
There is a gap between
the water tank and the
attached nozzle.
Mist flow comes out from
around the nozzle.
