10
LIFE | M7 X/M7 X UC NG
LifeIonizers.com/support
Important to Remember
• You must run 2-3 gallons of water through the pre-filters before
you connect them to the ionizer. To do this, install the pre-filters
into their housings, connect a piece of tubing to the outlet con-
nection on the pre-filter housing and run it into the sink so you
can flush them out with water. This hydrates the filters and cleans
them from any loose media. After you finish this procedure, con-
nect your pre-filter back to your ionizer and run normally. This
needs to be done every time you put in new pre-filters.
• The pre-filter housings must be replaced every 2 years.
Pre-filter Installation & Maintenance
Ionizer Installation
• Plugs located on the bottom of the ionizer must be removed
before installation.
• Do not overtighten the patch cable connection on the back of
the ionizer when plugging in patch cable.
• Run the ionizer and check for leaks at all tubing locations from
the Diverter Valve to the Ionizer itself before operating the unit.