3
Check that the distance “C” on the gate support structure is no greater than the value given in the table below. If the distance is higher than this value,
it is necessary to intervene by making a niche in the structure to obtain the indicated value. This is to avoid the linear operator colliding with the edge of
the structure during closure. The niche must be made in the area in which the linear operator is to be installed and it must have a height such as to allow
operator passage.
2.3
Rear and front bracket positioning
a) Define the clamping position of the rear bracket (1) of the operator, observing
the distances A, B and C.
b) Check that the outlet of the pipe housing the electric cables is below the
bracket (1).
c) Check that there is enough space on the leaf, at the point in which the operator’s
front bracket is to be clamped, and that the surface is suitable for clamping (with
screws or by means of welding).
d) Fix (with screws or by means of welding) the rear bracket (1) to the pillar in the
established position.
e) Make sure that the rear bracket (1) is perfectly level.
a. Take the leaf to the closure position, resting it against
the closure stop plates.
b. Position the front bracket (2) at distance E from the rear
bracket (1) and 80 mm lower.
The value of
E
must be just lower
(10 mm)
than
D
(maximum space between centres) to allow optimal stop plate adjustment.
a) Temporarily block the front bracket
(2)
with a clamp.
b) Check that the bracket is level using a spirit level.
OP324 UNI
OP524 UN
Ω
OP3 - OP3L - OP3 UNI – OP3L UNI – OP324 OP5 – OP5L – OP5UNI – OP5L UNI – OP524
AMAXmm BMAXmm CMAXmm D*mm AMAXmm BMAXmm CMAXmm D*mm
Ω1=90°
140
140
90 max 755 210 210 140 max 905
Ω2=120° 140
100
50 max
755 210 120 70 max 905
1
1
1
2
2
E
OP3= 745
E
OP5= 895
80
1
A
B
D
C
Ω
Ω
1
2
E
A
A
B
B
C
OP3 - OP3L - OP3 UNI – OP3L UNI
OP5 – OP5L – OP5UNI – OP5L UNI
OP324-OP324UNI
OP5-OP5L–OP524 UNI
E
745 mm
895 mm
OPTIMO 3
OPTIMO 5
C
ENGLISH
WWW.Roham-tech.ir
