9
Step 3
Lift the front end of Main Frame (5) up by two or more people and then attach the Main
Frame (5) onto the Left/Right Handlebar Support Tubes (10, 11) with two M10x55mm Bolts
(50) and two M10 Washers (60). Tighten bolts with the 6M Allen Wrench provided.
Please do not fully tighten the bolts until the computer bracket is installed.
Connect the Sensor Wire (32) from the Main Frame (5) to the Extension Sensor Wire I (33)
from the Right Handlebar Support Tube (11).
Remove one M8x35mm Bolt (44), one Ø8.2xØ16x2T Nylon Washer (54), and one M8 Nylon
Nut (57) from the Safety Tube A (24). Remove bolt and nylon nut with the 5M Allen
Wrench with Phillips Screwdriver and Hex Wrench provided.
Remove one M8x40mm Bolt (43), one Ø8.2xØ16x2T Nylon Washer (54), and one M8 Nylon
Nut (57) from the Safety Tube B (26). Remove bolt and nylon nut with the 5M Allen
Wrench with Phillips Screwdriver and Wrench provided.
Lift up the Main Frame (5) and hold it by one person, release the Spring Knob (27) by the
other person and pull the Safety Tube A (24) to stretched-out. Attach the Safety Tube B (26)
onto the L-plate on the Base Frame (7) with one M8x40mm Bolt (43), one Ø8.2xØ16x2T
Nylon Washer (54), and one M8 Nylon Nut (57) that were removed. Tighten bolt and nylon
nut with the 5M Allen Wrench with Phillips Screwdriver and Hex Wrench provided.
Attach the Safety Tube A (24) onto the Main Frame (5) with one M8x35mm Bolt (44), one
Ø8.2xØ16x2T Nylon Washer (54), and one M8 Nylon Nut (57) that were removed. Tighten
Hex Wrench
Tool:
Allen Wrench with
Phillips Screwdriver 5M
Allen Wrench 6M
60 50
60
50
33
32
11
10
54
57
5
5
43
26
27
7
24
54 57
44
24
54 57
44
