5.
Locate a BOTTOM HANDRAIL SPACER (#8). Insert the BOTTOM
HANDRAIL SPACER between the bottom of the HANDRAIL (#4) and the
FRAME (B) with the long taper facing the front of the unit as shown. Align the
two mounting holes in the HANDRAIL, BOTTOM HANDRAIL SPACER, and
FRAME and insert two LONG MOUNTING BOLTS (#7) and tighten securely
using a 5/32” hex key wrench.
6.
After securing the USER RIGHT SIDE HANDRAIL (#4 or #11) to the
USER RIGHT UPRIGHT (#2), remove the USER LEFT UPRIGHT
rear mounting bolt and carefully twist THE USER LEFT UPRIGHT
(#1) outward until the rear mounting flange is off of the FRAME (B).
NOTE:
be careful not to tilt the USER LEFT UPRIGHT (#1) from under the
DISPLAY CONSOLE (#3) when twisting the USER LEFT UPRIGHT outward.
REMARQUE :
veiller à ne pas incliner le MONTANT DE GAUCHE (nº 1)
sous la CONSOLE D’AFFICHAGE (nº 3) lors de son orientation vers
l’extérieur.
Reach a finger up into the ACCESS HOLE (E) located under the USER
LEFT UPRIGHT mounting flange and guide the 10-PIN CONNECTOR (10P)
of the WIRE HARNESS (C) that was fed into the USER LEFT UPRIGHT
through the BOTTOM CABLE ROUTING HOLE (F) of the USER LEFT
UPRIGHT. Carefully pull the excess wire from within the USER LEFT
UPRIGHT. Plug the 10-PIN CONNECTOR into the CONTROL BOARD (G)
located in the MOTOR COMPARTMENT (H). Feed any excess wire back into
the USER LEFT UPRIGHT.
NOTE:
Be careful not to damage the WIRE HARNESS (C) when pulling it
through the BOTTOM CABLE ROUTING HOLE (F) in the USER LEFT
UPRIGHT (#1).
REMARQUE :
Veiller à ne pas endommager le faisceau de CABLES (C) lors
de son passage dans l’orifice d’acheminement de CABLES INFERIEUR (F)
du MONTANT DE GAUCHE (nº 1).
7.
Carefully twist the USER LEFT UPRIGHT back into position on the FRAME (B)
and re-insert the rear MOUNTING BOLT (#10). Tighten the BOLT using a
9/16” combination wrench until snug and then back it off 1/4 turn.
NOTE:
Be careful not to damage the WIRE HARNESS (C) when twisting the
USER LEFT UPRIGHT (#1) back into position.
REMARQUE :
Veiller à ne pas endommager le faisceau de CABLES (C) lors
de la remise en place du MONTANT DE GAUCHE (nº 1).
8.
Repeat
Steps 5 and 6
to assemble the USER LEFT HANDRAIL.
Tighten all five mounting bolts and then back them off one full turn.
7
C
1
10P
G
H
F
4
7
8
B
C
F
10P
1
E
B
1
D
3
B
