manualshive.com logo in svg

Life Fitness TR9100, Replacement /Installation Instructions, Page: 1 / 4

Share
Download
Life Fitness TR9100 Replacement /Installation Instructions Download Page 1

Life Fitness Model TR9700, TR9500, TR9100 Treadmills

How To...Replace or Install Rear Roller Guards

Tools Required: 

Philips Screwdriver

NOTE: The following steps are applicable to units with Configuration No. 1, Rear Roller Guards.

1. 

Remove the Screws securing the Rear Roller Guard Assembly to the Frame.

2. 

Remove the old Grommets from the Rear Roller Welded Guard Tab and Base Frame (model
specific).

3. 

Install the new Grommets (included in kit) in the Rear Roller Guard Weldment and Base Frame
locations.

4. 

Place new Roller Guard in position as shown with the top surface under walking belt. Align mounting
holes.

Roller Guard to be

located between belt

and deck

Align mounting holes
with grommet holes

Cover Guard 

Roller Guard, RT
Roller Guard, LT

Screw

Grommet

Screw

Grommet

Configuration No. 1

Summary of Contents for TR9100

Page 1: ...e Frame 2 Remove the old Grommets from the Rear Roller Welded Guard Tab and Base Frame model specific 3 Install the new Grommets included in kit in the Rear Roller Guard Weldment and Base Frame locations 4 Place new Roller Guard in position as shown with the top surface under walking belt Align mounting holes Roller Guard to be located between belt and deck Align mounting holes with grommet holes ...

Page 2: ...all Rear Roller Guards 5 Install Screws and fasten securely Approx 22 37 in lbs 6 Repeat steps for opposite side After completion run treadmill and check for interference or binding If needed loosen Mounting Screws re align Guard and refasten securely Secure Mounting Screws ...

Page 3: ...nting screws on top and base of frame 2 With flat blade screwdriver remove Grommet and Washer discard old washer and re install the grommet Use caution to prevent injury or damage to paint NOTE Do not replace washer Having a washer and the grommet will raise the guard too high and cause rubbing against the belt resulting in premature wear and reducing belt life 3 Remove the Base s Lower Head Gromm...

Page 4: ... Align mounting holes 5 Install Screws and fasten securely Approx 22 37 in lbs 6 Repeat steps for opposite side After completion run treadmill and check for interference or binding If needed loosen Mounting Screws re align Guard and refasten securely Roller Guard to be located between belt and deck Align mounting holes with grommet holes Secure Mounting Screws M051 00K58 A128 ...

Reviews:

No comments