30
Maintenance
MAINTENANCE SCHEDULE
Procedure
Time
Engine Oil Check
Each Use
Replace Engine Oil
After each 40 hours of use (for initial break-in: after
first 10 hours of use)
Air Cleaner Filter
Check each use / clean as needed / replace after
every 100 hours of use
Spark Plug
When needed or max 100 hours run time
Valve Clearance
Check & re-adjust annually or after 50 hours of use
Fuel Tank
Replace every 3 years based on condition
NOTE:
refer to the following procedures for proper methods to perform
maintenance.
ENGINE OIL CHANGE PROCEDURES: Do not run without proper
water supply to high pressure pump to avoid damaging pump.
Periodic Maintenance of your engine oil should be performed after each 40
hours of use of your Power Equipment Product. Check your engine oil level
prior to each use.
1. Start your engine and let it warm up to get the oil warm and thinner. After
warm up turn engine off. Be sure during warm up sufficient inlet water is
supplied to unit and gun trigger is depressed to avoid damage to the
pump. Remove the dipstick (Refer to Controls and Features section) by
turning counter-clockwise. Remove the oil drain plug (Refer to Controls
and Features section) located below the dipstick utilizing the
appropriate tools. During warm up on pressure washer always supply
inlet water and depress spray gun to circulate water in pump to avoid
damage to pump.
CAUTION: THE OIL MAY BE HOT!
