HAL
Operation manual
OPERATION INSTRUCTIONS
This chapter describes the use of the complete range of HAL200 bullfloats.
TIP:For the location and description of the bullfloat’s parts, which are mentioned in the
text, we refer to the illustration figure 1 on the backside of the cover.
HOW TO ASSEMBLE THE HAL 200 BULLFLOAT.
When delivered the bullfloat is not ready for use.You only have to carry out the following
procedures.
1
Connect the switch ( an ON/OFF-switch, an electronic speed regulator, or a gasthrottle),
to the operating handle by means of the bracket and the butterfly nut.Now lock the bracket
by tightning the butterfly nut.
2
Stick the operating handle into the shaft of the motorunit-frame.Make sure that the operating
handle is locked in the proper way.
Figure 2 Assembly of the controls.
HOW TO ADJUST THE TROWEL BLADE ANGLE.
Adjusting the blade pitch
Use position (1) when smoothening normal freshly poured concrete.
6
