Troubleshooting Problems and Solutions
21
Data Video Projector
User Manual
11
Troubleshooting Problems and Solutions
You can check the status of the projector using the indicators on
the projector's control panel. Refer to the table below for the cause
of problems.
12
Resetting the Projector to Factory Default Settings
The factory default settings of the projector can be restored.
1 Press
the
Menu- button
on the operator touch panel or remote control.
2 Select the menu
„Management
“ using
the
Disc Pad
or remote
control.
3 Select Reset all
►
press <right>
13
FCC Compliance Statement For United States Users
This Equipment has been tested and found to comply with the limits far a class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instruction manual,
any cause harmful interference to radio communications.
Operation of this equipment in a resitental area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
Warning:
A shielded-type power cord is required in order to meet FCC emission limits and also to
prevent interference to the nearby radio and television reception. It is essential that only
the supplied power cord be used.
Use only shielded signal cables to connect I/O devices to this equipment.
Power
Lamp
Temp
Indicators
Standby condition
Warm-up (40 sec) or Cool-down (60 sec)
Projection
The lamp cover or the air filter cover is detached.
Attach the cover securely.
The lamp operates abnormally.
Contact the qualified service personnel.
The fan is broken.
Contact the qualified service personnel.
The internal temperature is unusually high.
Wait until the projector cools down, and turn on the power again.
Status
Cause & Remedy
: Flashing
: Lighting