11
Alignment
All Merlin 35 are adjusted on the laboratory test equipment with accuracy from 0.1 mrad to 0.3 mrad.
The fina
l accuracy depends on customer rifle scope, parallax of used rifle scope and shooting distance.
Merlin 35 is preset on 350m .
Customer who would like to use device on the shorter distance could recognise deviation and eliminate it
by software correction.
The manufacturing process of the NightSeers ensures the shooting precision tolerance within 3 to 7 cm
at 100 m. To achieve better result accuracy, use Alignment Correction in main menu. (last icon)
All NightSeers are preset in position X:0, Y:0.
Manual for electronic accuracy correction.
1) Aiming your daytime scope to the middle of target and shoot. This is test process of control good daytime
scope accuracy.
2) Put Merlin 35 on the rifle scope using adapter. Aim to the thermal target and shoot again.
3) Measure horizontal distance (x) and vertical distance (y) between shoot and aiming position from step 2).
4) Long press up button to enter main menu, you will see Alignment Correction as the last icon of the menu.
Short press up button to enter this sub-menu.
When the point of impact with Merlin35 is on the Right side of previous point of impact
(previous aiming position), change value X (X- => pressing button Down), decrease X value, and vice versa.
When the point of impact with Merlin35 is on the Up side of previous point of impact
(previous aiming position), change value Y (Y- => pressing button Down), decrease Y value, and vice versa.
While using the Alignment Correction is shown value of axis X and Y, one step for camera
Merlin35 means 1,66 MOA = 4.8cm on 100m
BH
Alignment
x=00 y=00
