10
11
Step 5: Install the Slide Assembly
(top of bench)
(end of
bench)
Place the Slide Assembly (Part
#4) into the mortise you cut in
your bench. Position it so that the
standoffs are facing towards the
end of the bench. Make sure that
it is parallel to your bench top.
Use a 3/8" transfer punch to mark
the centers of the five holes. Then
remove the Slide Assembly and
drill the holes 2" deep with a size
5/16" drill bit. Thread the holes us-
ing a 3/8-16 tap.
Mount the Slide Assembly in
the mortise and install the bolts
(Part #9) as shown using a 7/32"
hex driver.
Note that the flat head bolt goes
in the hole between the standoffs.
