3. OPERATION
Initial Start-up
Warm-up time of 15 minutes stabilizes the measured values after switching on.
3.1. Basic Operation
1. Power On/Off:
Switch on the balance by pressing on/ off key.
The display is switched on and the test is started and if want to switched off, press
again the key.
2. Zero
Environmental conditions can lead to the balance exactly zero in spite of the platform
not taking any strain. However, you can set the display of your balance to zero any
time by pressing
key and therefore ensure that the weighing starts at zero.
3. Tare
The weight of any container can be tared by pressing
button so that with
subsequent weighing the net weight of the object being weighed is always displayed.
•
Load weight on the platform.
•
Press
key. Zero is displayed, and tare is subtracted.
•
Remove weight on the platform. Tared weight is displayed. It can set only one tare
value. It will be shown with a minus value.
•
Press G/N to change between gross weight and net weight.
•
To clear the tare value, remove the load and press
key. Zero is displayed, tare
weight is cleared.
3.2. Accumulation
The scale can be set to accumulate manually by pressing
key. Before operation scale
should be stable and return to zero, accumulation available only when weight more than 20d
Accumulation Operation
•
Place the load on the platform.
•
Press
key, when displayed STABLE indication.
•
Display will be show
acc 1
then will be show the total saved value. These displays
will be shown only three seconds.
•
Remove the weight from the pan.
•
When display get zero and stable then place the second weight.
•
It can continue until the memory gets fully or 99 items.
