Libelium Waspmote Smart Parking v2, Technical Manual

Page: 24 / 155

Smart Parking node
3.7. Node parameters
3.7.1. Parameters description and ranges
The Smart Parking node has different parameters that change the timing and detection performance of the node.
The next table shows the node parameters:
Parameter Range Description
Sleep time 1-10 min or 20-59 s Minutes or seconds elapsed between each measurement cycle
Keep-alive time 0.5, 1, 2,..., 23 hour
Hours elapsed since last uplink message which triggers a new
Keep-alive frame
Night-mode 0 or 1 Night-mode disabled/enabled
Night-mode start 0, 1,..., 23 hour Night-mode starts when RTC reaches this parameter fi eld
Night-mode duration 1, 2,..., 15 hour Night-mode period is equal to this fi eld
Night-mode sleep 1, 2,..., 10 min Sleep time applied during night-mode
Radar range start 20 to 50 cm
Starting measurement distance (objects below this value are not
detected)
Radar range length 50 to 100 cm Range of measurement to be added to "range start" value
Radar threshold 5 to 100
Threshold used in detection algorithm, so higher threshold imply
less sensitive detection
LoRaWAN join mode 0 (ABP) or 1 (OTAA) Join mode used by the LoRaWAN radio module
LoRaWAN DevEU I 8-byte identi fi er De fi nes the device EU I used by the LoRaWAN radio
LoRaWAN DevAddr 4-byte identi fi er
De fi nes the device address used by the LoRaWAN radio in ABP
mode
LoRaWAN NwkSKey 16-byte key
De fi nes the LoRaWAN Network Session Key used by the LoRaWAN
radio in ABP mode
LoRaWAN AppSKey 16-byte key
De fi nes the LoRaWAN Application Session Key used by the
LoRaWAN radio in ABP mode
LoRaWAN AppKey 16-byte key
De fi nes the LoRaWAN Application Key used by the LoRaWAN radio
in OTAA mode
LoRaWAN AppEU I 8-byte identi fi er
De fi nes the LoRaWAN Application EU I used by the LoRaWAN radio
in OTAA mode
LoRaWAN port 1 to 223 De fi nes the port used for uplink sendings
LoRaWAN ADR 0 (o ff ) or 1 (on) De fi nes if Adaptive Data Rate is enabled or disabled
LoRaWAN RX1 Delay 0 to 65536 De fi nes the delay after fi rst LoRaWAN rx window
LoRaWAN Subband 8-bit bitmap
De fi nes the sub-band used by the LoRaWAN radio (only applies to
US and AU versions)
I mportant :
The LoRaWAN identi fi ers and keys must be registered in the LoRaWAN network server before starting the node in
order to receive data. For OTAA mode: DevEU I , AppEU I and Appkey. For ABP mode: DevEU I , DevAddr, NwkSKey and
AppSKey.
- 23 - v7.5