ColorSave 1000ST-INJ user manual
38
Symptom
Possible cause
Correction actions
Material blocked at screw's exhaust
tube and doesn't stream out
-Try to replace the screw with another
type
-Ask for help — it might be that the
material is too sticky and can't be used
with this feeder
5.9 Control Parameters
This screen is for Maintenance crew use only.
Enter Maintenance screen
Press Information button to display
Information screen
Note: These parameters are important for maintenance purposes, but not for ongoing normal
operation
▪
Actual
▪
Actual percentage
▪
Dose Time
▪
The last dosing time
▪
Inj. Time
▪
The last injection time
▪
Weight
▪
Weight of material in the hopper
▪
Speed
▪
Motor's speed
▪
G/R
▪
Gram per rotation (see section 4.1.4 Gram Per Rotation)
▪
Last shot
▪
The weight of the last shot
▪
Cycle Time
▪
The last cycle time
▪
Pulses
▪
The number of pulses to the motor during the last cycle
▪
▪
When the sign is red this means the ColorSave is still learning. When
it becomes green this means the ColorSave has finished learning