7.
Remove the two screws shown below that secure the battery bracket, and remove the battery assembly from the enclo-
sure.
8.
Install the new battery assembly in the enclosure using the two screws removed in Step 7. Plug in the battery connec-
tor.
Battery connector
Battery and
bracket
9.
Carefully position the PC board in the enclosure and loosely install the four screws on the bottom of the enclosure.
Loosely install the two screw locks on the RS-232 connector. After all of the screws are started, tighten the four screws
on the bottom of the enclosure and the two screws on the RS-232 connector.
Screw
locks
10.
Check the ribbon cable connector and make sure the retainer clip is in the “up” position.
3
