LGMG AS1932E, Operation And Safety Manual

Page: 35 / 68

LGMG North America Inc.
Operation and Safety Manual
27
7.12 Using the Safety Prop
1) Elevate the platform a specified height above
the ground (for elevation height, refer to the
following table).
Table 10 - Safety Prop Deployment Height
Model Height
SS1230E
7.9ft (2.4m) AS1932E
AS2646E
AS3246E 10.5ft (3.2m)
2) Lift the safety prop, move it to the center of
the scissor cross tube and rotate it upward
until it is vertical.
3) Lower the platform height until the safety
prop completely contacts the shaft tube.
Keep the platform away from the movable
parts during the lowering process.
△
! Danger
Do not carry any load in the platform
when the safety prop is in use. Do not
use the safety prop for a period longer
than 8 hours.
7.13 How to Stow the
Guardrail
On model SS1230E, the platform guardrail
system consists of a folding guardrail on an
extended platform and a folding guardrail on the
main platform.
1) Fully lower the platform and lock it into the
extended platform.
2) Remove the platform controller.
3) Remove the two retaining pins at the front of
the extended platform from the inside of the
main platform.
4) Push the front guardrail of the extended
platform inward. Do not place your hands in
places where there may be a pinch point.
5) Remove the retaining pin of the left guardrail
of the extended platform and fold the left
guardrail of the extended platform inward. Do
not place your hands in places where there
may be a pinch point.
6) Remove the retaining pin of the right
guardrail of the extended platform and fold
the right guardrail of the extended platform
inward. Do not place your hands in places
where there may be a pinch point.
7) Install the four retaining pins which were
removed back to the guardrail on each side.
8) Remove the two retaining pins on the upper
part of the door.
9) Push the door guardrail from the ladder or the
ground inward. Do not place your hands in
places where there may be a pinch point.
10) Remove a retaining pin from the left guardrail
of the main platform.
11) Push the left guardrail of the main platform
from the ladder or the ground inward. Do not
place your hands in places where there may
be a pinch point.