LGMG AR16J, Maintenance Manual

Page: 21 / 32

Maintenance Manual of Elevating Work Platform
16
Engine lubricating oil
consumption
excessive
Lube oil level too high
Check lube oil level, if necessary drain
off
Excessive inclination of engine
Check engine mounting / reduce
inclination
Crankcase breather Check/replace
Lubricating oil in the exhaust
system
Engine operated continuously with too low
a load (< 20-30%)
Check load factor
Valve shaft seals defective Check/replace
Exhaust gas turbocharger defective Check/replace
Engine producing blue smoke
Lube oil level too high
Check lube oil level, if necessary drain
off
Excessive inclination of engine
Check engine mounting / reduce
inclination
Engine producing blue smoke
Lube oil level too high
Check lube oil level, if necessary drain
off
Excessive inclination of engine
Check engine mounting / reduce
inclination
Engine producing white smoke
Fuel quality does not comply with
operating manual
Change the fuel
Injector defective Change
Condensation
Warm up engine so that water residues
evaporate
Engine producing black smoke
Air filter clogged / turbocharger defective Check/replace
Air filter maintenance switch /
maintenance indicator defective
Check/replace
Charge air line leaking Check charge air line
Injector defective Change
Air filter clogged / turbocharger defective Check/replace
Charge air line leaking Check charge air line
Injector defective Change
Differential pressure of flow meter
defective
Change
Nox sensor defective Change
Differential pressure sensor of diesel
particulate filter is issuing an implausible
signal
Change
Differential pressure line added Clean
1.19 Engine fault codes
KWP-Code SPN FMI
Error Identification
45 168 3
Battery voltage: The voltage measured by ECU is out of the target
range, system reaction is initiated.
46 168 4
Battery voltage: The voltage measured by ECU is out of the target
range, system reaction is initiated.
47 168 2
Battery voltage: The voltage measured by ECU is out of the target
range,system reaction is initiated.
84 639 14
CAN bus 0: The ECU is not allowed to send messages because the
status "BusOff" is detected.
85 1231 14
CAN-Bus 1: The ECU is not allowed to send messages, because
the status "BusOff" is detected.
Warning, no diagnostic with SERDIA2010 is possible.
88 102 2
Charge air pressure measured by sensor is above the warning