LG WT5680H A, Owner'S Manual

Page: 35 / 80

35
ENGLISH
TROUBLESHOOTING
ERROR CODES
Problem Possible Cause Solutions
The display shows: The lid is not closed properly. Make sure that the lid is closed properly
and press the START/PAUSE button. After
starting a cycle, it may take a few moments
before the tub begins to turn or spin. The
washer will not spin unless the lid is locked.
If the lid is closed and the lid lock error mes-
sage is displayed, call for service.
The display shows: Lid lock switch error. Make sure that the lid is closed properly and
press the START/PAUSE button. The washer
will not operate unless the lid is locked.
Make sure that nothing is caught under the
lid, including shipping material or clothing.
Make sure that the latch mechanism is fully
retracted.
If the lid is closed and the lid lock error mes-
sage is displayed, call for service.
The display shows: Special Drain Feature. If the washer is paused during a cycle for
more than five minutes, the cycle will be
cancelled and any water remaining in the tub
will be drained.
Washer fills with water slowly or
not at all, or the display shows: Water supply faucets are not fully
open. Make sure that the water faucets are fully
open.
Water line hoses are kinked,
pinched, or crushed. Make sure that the hoses are not kinked or
pinched. Be careful when moving the washer
during cleaning and maintenance.
Water inlet filters are clogged. Clean the inlet filters. See Maintenance in
the Care and Cleaning section.
Water supply pressure to faucet or
house is too low. Check another faucet in the house to make
sure that household water pressure is ad-
equate and flow is not restricted. Disconnect
the inlet hose from the washer and run a few
gallons of water through the hose to flush
the water supply lines. If flow is too low,
contact a plumber to have the water lines
repaired.
Water supply connected with leak-
limiting hoses. Hoses designed to limit leaks can trip falsely
and prevent the washer from filling. The use
of leak limiting hoses is not recommended.
Washer will not turn on Power cord is not properly
plugged in.
House fuse is blown, circuit break-
er has tripped, or power outage
has occurred. Make sure that the plug is plugged seruely
into a grounderd, 3-prong. 120-VAC, 60-Hz.
outlet.
Reset circuit breaker or replace fuse. Do not
increase fuse capacity. If the problem is a
circuit overload, have it corrected by a quali-
fied electrician.