28
Maintenance
M
aintenance
CLEAN THE PUMP CASING (when drainage is bad)
1
2
3
4
Place a towel on the
floor under the drain
pump cap. Excess
water may flow out.
Turn the cap
counter- clockwise
and pull it out.
Remove any foreign
objects and fluff inside
pump casing and from
the filter.
Replace the cap.Insert the
filter along the guide ribs
inside the pump casing.
Filter must face the guide
ribs inside pump casing
and securely turn the cap
clockwise.
CAUTION
: Check it over if water leaks after reassembling. (Rubber ring is in the cap)
WHEN THERE IS A FEAR OF FREEZING
1.
Close the water taps and remove the water supply hoses.
2.
Hold the water supply hoses as shown in the drawing so that it
does not sag.
3.
Set the POWER button to "ON"and the WATER TEMP. to
warm.
4.
Press START/PAUSE button and operate the washing
machine for 20 seconds.
• Water which remains in the water supply is removed.
5.
Press START/PAUSE button to stop the operation.
6.
Lower the drain hose and select manual spin mode.
7.
Press START/PAUSE button and operate for 30 seconds.
Set the POWER button to "OFF".
• Drain the water in the bowl and the drain hose.
IF FROZEN
1.
Remove the water supply hose, and immerse it in
hot water at approx.40 °C.
2.
Pour approx. 2 liters of hot water at approx. 40°C,
into the bowl for 10 minutes.
3.
Connect the water supply hose to the water tap, and
confirm that the washing machine performs the
supply and drainage of water.
Cap
Filter
Guide rib
Filter
