WM2688H*M
Steam
Washer
The air vent on the back of the machine must be left open and clear at all times.
If the washer is installed in a closet or closed laundry alcove, there must be
sufficient clearance and ventilation. The closet should have a full louvered door
with at least 800 square inches (0.5 m
2
) of open area for ventilation.
The washer requires a space of at least 1 inch (2.5 cm) between the wall and the
machine on each side and at least 4 inches (10 cm) between the back of the
washer and the wall. Additional space may be needed for servicing.
ACCESSORIES
The washer comes with the two input hoses. The blue stripe is for cold water and
the red stripe is for hot water. While the hoses are mechanically identical, it is
critical to the performance of the washer to have the hot and cold hoses
connected correctly.
The wrench is used to remove (and replace) the shipping bolts and to adjust the
leveling feet. Be sure to leave it and encourage the customer to retain the wrench,
the four shipping bolts, and the manual in a safe place in the event the washer
requires service or the customer moves.
The shipping bolts
MUST BE REMOVED
before operating the washer. (See
page 15.)
WM2688H*M
Page 13 of 64
TRAINING MANUAL
