10cm
CAUTION
I
nstallation
7
Introduction
Install the washing machine on a flat and firm surface.
Level the washing machine
●
Install the washing machine on a level and firm surface.
●
Keep the washing machine more than 10cm from the wall to prevent vibration noise during spinning.
●
The base opening must not be obstructed by carpeting when the washing
machine is installed on a carpeted floor.
●
Wooden floors may need reinforcing to prevent the normal vibration which
occurs with an unbalanced load.
❏
Check the level of the washing machine using a
spirit level on the side of the washing cabinet
❏
You can check the level also by visually lining up the
washer with the fills, adjacent walls or cabinets.
❏
You can level the washer using the A.L spindle fitted to the cabinet.
●
Screw the A.L SPINDLE legs up or down as required.
●
Additional height adjustment plates are provided in the accessory bag. These fit under A.L SPINDLE
if required to allow for greater adjustment of the legs.
●
When washing machine does not even out, turn A.L SPINDLE
right or left to be level.
●
Should the height adjustment exceed the maximum
allowed by the A.L SPINDLE, place height
adjustment plats provided under
the legs as shown in the
diagram.
●
If the washer is installed on a uneven,weak or tilted floor causing excessive vibration,
spin failure or
” error can happen to it.
It must be placed on a firm and level floor to prevent spin failure.
●
If the appliance is supplied from a cord extension set or electrical portable outlet
device the core extension set or electrical portable outlet device should be
positioned so it is not subject to splashing or ingress of moisture.
A.L SPINDLE
UP
DOWN
1 plate used 2 plates used 3 plates used 4 plates used
