Connecting Water Supply Hose
30
Separate Middle connector from Water Supply Hose
Separate Middle connector from the Water
Supply Hose by pulling the Pressing Rod and the
Pressing Handle that is attached to the Water
Supply Hose.
Loosen the fixed nuts to connect the connector to the tap
Untighten the screw of the connector so that the
tap can be placed in the middle.
Fixing Connectors to the Tap
Push the upper connector up till the rubber pack-
ing is in tight contact with the tap. Then tighten
the 4 screws.
Fixing Upper Connector and Middle Connector
Remove the fixed sticker in between the Upper
and Middle Connectors. Tighten the connectors
by holding one connector and twist middle con-
nector to the right.
Connecting Middle Connector and Water Supply Hose
Press down the pressing rod of the Water Supply
Hose which was separated from middle connector
(refer to Step1) and then join it to the middle con-
nector.
Normal Type
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Pressing Rod
Pressing Rod
Connector
Connector
Connector
Middle
Connector
Middle
Connector
Pressing handle
Pressing rod
Water Supply Hose
Fixed sticker
Guide plate
Fixed sticker
screw
Middle
Connector
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Pressing Rod
Pressing Rod
Connector
Connector
Connector
Middle
Connector
Middle
Connector
Pressing handle
Pressing rod
Water Supply Hose
Fixed sticker
Guide plate
Fixed sticker
screw
Middle
Connector
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Pressing Rod
Pressing Rod
Connector
Connector
Connector
Middle
Connector
Middle
Connector
Pressing handle
Pressing rod
Water Supply Hose
Fixed sticker
Guide plate
Fixed sticker
screw
Middle
Connector
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Pressing Rod
Pressing Rod
Connector
Connector
Connector
Middle
Connector
Middle
Connector
Pressing handle
Pressing rod
Water Supply Hose
Fixed sticker
Guide plate
Fixed sticker
screw
Middle
Connector
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Pressing Rod
Pressing Rod
Connector
Connector
Connector
Middle
Connector
Middle
Connector
Pressing handle
Pressing rod
Water Supply Hose
Fixed sticker
Guide plate
Fixed sticker
screw
Middle
Connector
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Pressing Rod
Pressing Rod
Connector
Connector
Connector
Middle
Connector
Middle
Connector
Pressing handle
Pressing rod
Water Supply Hose
Fixed sticker
Guide plate
Fixed sticker
screw
Middle
Connector
Fixed Sticker
Pressing Handle
Pressing Rod
Water Supply Hose
Pressing Rod
Pressing Rod
Connector
Connector
Connector
Middle
Connector
Middle
Connector
Pressing handle
Pressing rod
Water Supply Hose
Fixed sticker
Guide plate
Fixed sticker
screw
Middle
Connector
If the tap diameter is too large or is square,
untighten the 4 screws and remove the guide
plate. Then follow step1.
In case tap is too large.
NOTE
Check for water leakage
After connecting the hose, open the tap to check
for any water leakage.
If the connection leaks, close the tap and start
again from step 1.
If you skip step 1, water leakage may occur.
(Normal tap without thread & one touch type inlet hose.)
1
2
3
4
5
6