12
Leveling the Washing Machine
If the floor is uneven, turn the adjustable feet as required
(Do not insert pieces of wood etc. under the feet). Make
sure that all four feet are stable and resting on the floor
and then check that the appliance is perfectly level (Use
a spirit level).
•
Once the washing machine is level, tighten the lock
nuts up towards the base of the washing machine. All
lock nuts must be tightened.
Raise
Lock Nut
Lower
Tighten all 4
locknuts securely
•
Diagonal Check
When pushing down the edges of the washing
machine top plate diagonally, the washing machine
should not move up and down at all (Check both
directions). If the washing machine rocks when
pushing the machine top plate diagonally, adjust the
feet again.
NOTE
•
Timber or suspended type flooring may contribute
to excessive vibration and unbalance.
•
Do Not install the washer on a raised platform,
plinth or stand, unless it is manufactured and
specified for its purpose by LG Electronics.
Connecting Inlet Hose
•
Water supply pressure must be between 0.1 MPa and
0.8 MPa (1.0‒8.0 kgf/cm
2
).
•
Do not strip or crossthread when connecting inlet hose
to the valve.
•
If the water supply pressure is more than 0.8 MPa, a
decompression device should be installed.
•
Periodically check the condition of the hose and
replace the hose if necessary.
Checking the Rubber Seal on the Inlet
Hose
Two rubber seals are supplied with the water inlet hoses.
They are used for preventing water leaks. Make sure
they are present when connecting the inlet hoses. Firmly
Hand tighten the inlet hoses. Do not overtighten or use
and mechanical devises to tighten the inlet hoses.
Hose connector
Rubber seal
Hose connector
Rubber seal
Summary of Contents for WD1475NPW
Page 39: ...Memo ...
Page 40: ......