LG WD1411SBW, Owner'S Manual

Page: 13 / 49

12
Leveling the Appliance
If the floor is uneven, turn the adjustable feet as required
(Do not insert pieces of wood etc. under the feet). Make
sure that all four feet are stable and resting on the floor
and then check that the appliance is perfectly level (Use
a spirit level).
•
Once the appliance is level, tighten the lock nuts up
towards the base of the appliance. All lock nuts must
be tightened.
Raise
Lock nut
Lower
Tighten all 4
lock nuts securely
Diagonal Check
•
When pushing down on the edges of the top plate
diagonally, the appliance should not move up and
down at all (Check both directions). If the appliance
rocks when pushing the machine top plate diagonally,
adjust the feet again.
NOTE
• Timber or suspended type flooring may contribute
to excessive vibration and unbalance errors and
malfunctions.
• Do not install the washer on any elevated surface,
stand or plinth as it can become unstable and fall
causing serious injury and damage.
Connecting Supply Hose
• Water supply pressure must be between 100~800 kPa
(1.0‒8.0 kgf/cm
2
).
• Do not strip or crossthread when connecting supply
hose to the valve.
• If the water supply pressure is more than 800 kPa, a
pressure limiting device should be installed.
•
Periodically check the condition of the hose and
replace the hose if necessary.
Checking the Rubber Seal on the Supply
Hose
Two rubber seals are supplied with each water inlet
hose.
They are used for preventing water leaks. Make sure the
connection to taps is sufficiently tight. Do not use any
mechanical device to overtighten the inlet hoses. Hand
tighten only with the aid of a soft cloth if necessary. After
both ends have been connected, open the taps slowly
and check for leaks.
Hose connector
Rubber seal
Hose connector
Rubber seal