LG WD-14570RD, Owner'S Manual

Page: 21 / 36

20
Tub Clean
Tub Clean course can be set by pressing
and holding Intensive and Pre Wash button
simultaneously.
When Tub Clean course is set, display
“
”, and all buttons are inoperable.
TUB CLEAN is special cycle to clean the
inside of the washer. This cycle uses higher
water level with higher spin speed. Perform
this cycle regularly.
How to use the Tub Clean cycle:
1. Remove any clothing or items from the
washer and close the door.
2. Open the dispenser drawer and add Anti
limescale (Calgon) to the Main wash
compartment.
NOTE: Do not add any detergent to the
detergent compartments. Excessive
suds may generate and leak from the
washer.
3. Close the dispenser drawer slowly.
4. Power On and then press and hold
Intensive and Pre Wash button for 3 seconds.
then “
” is displayed in LED.
5. Press the Start/Pause button to start.
6. After the cycle is complete, leave the door
open to dry around the washer door
opening, flexible gasket and door glass.
CAUTION: If there is a small child, be
careful not to leave the door
open for too long.
!
ow to use washer H
Child lock
If you choose to lock the buttons on the
control assembly to prevent tampering, this
function may be selected.
• Child lock can be set by pressing and
holding the Rinse+ and Medic Rinse
button simultaneously.
(About three seconds)
• When child lock is set, all buttons are
inoperable, except Power button
• To deactivate Child lock system, press and
hold the Rinse+ and Medic Rinse button
simultaneously again.
(About three seconds)
• To change to the desired program, whilst in
child lock mode.
1
. Press and hold both Rinse+ and Medic
Rinse button together once again.
(About three seconds)
2
. Press the Start/Pause button.
3
. Select the desired program and press the
Start/Pause button again.
• The child lock can be set at any time and it
is automatically canceled when operational
errors occur. Also
Child lock works when
power is off.