Disassembly
6. MOTOR
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 1)
3. Remove the cabinet. (Refer to Section 2)
4. Remove the control board. (Refer to Section 3)
5. Remove the air guide upper. (Refer to Section 4)
6. Remove the compressor, turbo fan, fan and shroud.
(Refer to Section 5)
7. Remove 2 screws that secure the motor to the
motor. (See Figure 22)
8. Remove the motor.
9. Re-install by referring to the procedures above.
7. AIR GUIDE
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 1)
3. Remove the cabinet. (Refer to Section 2)
4. Remove the control board. (Refer to Section 3)
5. Remove the air guide upper. (Refer to Section 4)
6. Remove the compressor, turbo fan, fan and shroud.
(Refer to Section 5)
7. Remove the motor. (Refer to Section 6)
8. Remove 2 screws that secure the air guide to the
base pan. (See Figure 23)
9. Push the air guide backward and lift it upward.
(See Figure 23)
10. Re-install by referring to the procedures above.
8. OVERLOAD PROTECTOR
1. Remove the front grille and cabinet.
(Refer to Section 1, 2)
2. Remove the nut which fastens the terminal cover.
3. Remove the terminal cover.
4. Remove all the leads from the overload protector.
5. Remove the overload protector.
6. Re-install the components by referring to the
removal procedure above. (See Figure 24 and 25)
9. COMPRESSOR
1. Remove the front grille and cabinet.
(Refer to Section 1, 2)
2. Discharge the refrigerant by using a refrigerant
recovery system.
3. Remove the overload protector.
(Refer to Section 8)
4. After discharging the unit completely, unbrace the
suction and discharge pipes at the compressor con-
nections.
5. Remove 3 nuts which fasten the compressor.
6. Remove the compressor.
7. Re-install by referring to the removal procedure
above. (See Figure 25)
Electrical Parts
Figure 22
Figure 23
Figure 24
Figure 25
Figure 22
Service Manual 11
