17
HOW TO CHARGE THE BATTERY
Check 1:
If the battery is not charging even when the Roboking 2.0 is
attached to the home station, check the following items.
- Turn the power switch on the bottom of the Roboking 2.0
off once and then on again.
- Check the power lamp of the home station.
- Wipe the terminal on the home station with a dry cloth
Check 2:
If the battery is still not charging after the previous check,
try the following.
- Manually attach the Roboking 2.0 to the home station.
- Press the reset button at the rear of the home station for
three seconds.
The remaining battery charge can be confirmed from the charge indication light, which will indicate charge
as follows:
• During charging, the charge remaining indication light will flicker.
• When charging is completed at the home station, only the battery icon will illuminate to save power.
• The battery icon will flicker when battery charging is required.
Full charging
(Under charging)
The status indication lamp
while the robot is charged
(In spatial expand mode)
High
Middle
Low
Charging is
required
※
If there is still an area to be cleaned when the Roboking 2.0
is returned to the home station for charging, the selected
cleaning mode is displayed.
- When the battery is fully charged, it cleans the area that
remains to be cleaned. (Perform 1 time)
- During charging, when the cleaning mode is displayed,
pressing the START button on the remote controller or
the START/STOP button on Roboking 2.0 will cause the
Roboking 2.0 to search for the un-cleaned area and start
cleaning.
- Pressing the mode selection button (ZIGZAG, CELL BY
CELL) will start the cleaning process from the beginning.
Remaining Battery Charge Indicator
If the Battery is Not Charging
Flickering
In the case of not
existing an area to
be cleaned
In the case of
existing an area
to be cleaned
(Flickering)
Charge
terminal
