LG V-UP142NJP, Owner'S Manual

Page: 19 / 41

18
Review the chart below for possible solutions in the event of a minor problem. Any
service needed, beyond the procedures described below and elsewhere in this manual,
should be performed by an authorised service centre.
BEFORE REQUESTING SERVICE
Problem
Vacuum
cleaner won’t
run
Vacuum
cleaner won’t
pick up
Dust
escaping the
dust
container
Possible Cause
1. Not plugged firmly into wall outlet
2. No voltage in wall outlet
3. On/Off switch not turned on
4. Blown fuse in the plug
5. Thermal overload protection
activated
1. Belt worn or broken
2. Worn agitator brush
3. Dust container full
4. Hose or nozzle blocked
5. Hose damaged
6. Dust container installed
incorrectly
7. Belt not installed on the motor
shaft
1. Dust container installed
incorrectly
2. Pre-motor filter cap installed
incorrectly
Possible Solution
1. Plug firmly into wall outlet.
2. Check fuse or circuit breaker.
3. Press the On/Off switch.
4. Change the fuse for a 13 Amp
ASTA approve fuse.
5. Turn the vacuum cleaner off,
unplug it, and allow it to cool.
(See page 3)
1. Replace the belt.
2. Replace the agitator.
3. Empty the dust container and
check the pre-motor filter.
4. See REMOVING BLOCKAGES
on page 13.
5. Replace the hose.
6. Make sure the dust container is
seated properly in the handle.
7. Install the belt on the motor
shaft. (See page 16.)
1. Make sure the dust container is
seated properly in the handle.
2. Make sure the pre-motor filter is
in place and seated correctly.
WARNING
Electrical Shock and Personal Injury Hazard
• Unplug the vacuum cleaner before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury.