6
3
How to attach to masonry walls
Please follow the below direction.
-
Check the material of the wall and the thickness of the finishing.
-
Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone
masonry brick and hallow block that do not crack.
-
Do not mount the device on the walls made from plasterboard or medium density fiberboard (MDF). In this
case, the anchor and screws must be inserted into the concrete behind the finish surface. If there is no
concrete on the other side, then you must first install a separate hanger to securely install the anchors and
screws.
-
When installing the product on wall material not designated, install the product so that each location can
withstand the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
a
b
d
e
Wall mount screw
c
Anchor
-
Use the Ø 8 mm drill bit for concrete and hammer (impact) drill.
a. Use a drill bit Ø 8 mm to drill a hole for the anchor location within a depth of 80 mm - 100 mm
b. Clean the drilled hole.
c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to
face upward.
e. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at Torque of 45 kgf/cm - 60 kgf/cm.
