10
INSTALLATION
3
Use side cutters or tin snips to cut out and
remove the knockouts
b
from the back plate
a
. Be careful not to distort the back plate.
Discard the knockouts.
4
To avoid pinching the blower wire, make sure
that it is channeled underneath and between
the two exhaust ports when they are rotated.
5
Rotate and reinstall the blower unit
a
so that
the exhaust ports
b
face the rear of the
cabinet and are aligned with the rear
knockouts. When you insert the blower unit,
the blower wire
c
must be routed as shown.
6
Attach the blower plate
d
to the microwave
oven so the blower unit exhaust ports
c
and
blower plate opening are aligned. Attach one
or two blower unit mounting screw(s)
f
and
then one or several blower plate mounting
screw(s)
a
.
b
Blower unit
e
Back plate
7
Insert the tabs on each side of the damper
into the holes at the inside rear of the
adapter. Attach the exhaust adapter
a
to the
back plate wall side. Push in securely until it is
past the top locking tabs
c
and in the lower
locking tabs
c
. Make sure that the damper
hinge is at the top and that the damper
swings freely.
b
Damper (hinge side up)
c
Guides
e
Slide exhaust adapter into guides on rear
panel.
Roof-Venting Installation
1
Follow steps 1 and 2 under Wall-Venting
Installation.
2
Rotate and reinstall the blower unit
a
so that
the exhaust ports
b
face the top of the
cabinet. When you insert the blower unit, the
blower wire
c
must be routed as shown.
us_main.book.book Page 10 Wednesday, May 4, 2022 1:09 PM
