EN
G
LI
SH
5
How to attach to masonry walls
- Check the material and thickness of the wall.
- Do not mount the device on a wall made with plaster board or medium density fiberboard (MDF). Otherwise,
you must attach the anchor and screws to the retaining wall (concrete) inside the finishing material. If there is no
retaining wall, you must install a separate hanger first and then attach the anchors and screws.
- When installing the product on any type of wall material, each screw location must be capable of withstanding a
pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
Please follow the directions below.
a. Use an
Ø
8 mm drill bit to drill a hole for the anchor location within a depth of 80 mm - 100 mm
b. Clean the drilled hole.
c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face
upward.
e. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 kgf/cm - 60 kgf/cm.
- Use an
Ø
8 mm drill bit for concrete and hammer (Impact) drill.
a
b
d
e
Wall mount screw
c
3
