5
EN
G
LI
SH
EN
G
LIS
H
3
How to install the wall mount
a. Use a drill bit Ø8 mm to drill a hole for the anchor location within a depth of 80 mm - 100 mm
b. Clean the drilled hole.
c. Insert the sealed anchor into the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward.
e. Align the wall mount bolts to the holes and tighten them by hand.
Then, fasten the bolts at a torque of 45 kgf/cm - 60 kgf/cm.
→
If the screw cannot be assembled in the designated location
inevitably, it can be assembled by rearranging to the closest
location. But, do not change 2 or more locations from the
designated spot.
→
Assemble the wall mount screw on 1 left and 1 right location
on the top part and 1 left and 1 right location on the bottom
part.
→
At this time, use a Phillips Head driver (Manual or motorized)
or 8 mm wrench to tighten the screw so that the wall, wall
bracket and screw are completely pressed against one
another.
Wall mount
screw
1. Set the display with the guide spacer assembled on the wall mount bracket on the wall in arrow direction. At this time, align
the bottom assembly part and lift the set up lightly to align the top part.
2. When adjusting the location, assemble the provide safety clip as shown in the picture to prevent the product from moving.
Tighten the safety clip screw completely. If the safety clip is not tightened as shown in the picture, the product can fall off.
→
Pull on the bottom of the set to make sure the display is secure.
→
When installing a display rotated, only rotate the display 90 degrees (portrait mode). (Only applies for VESA 200X200, 400x400)
→
When connecting cables and accessories, make sure that the product is installed at a sufficient distance from the wall to avoid
stress on them.
→
When you push the product with excessive force, the product can be damaged.
4
How to assemble the wall mount support and display
- Always install the display with 2 or more people.
Safety clip
Safety clip screw
* Assemble the wall mount
support, product and safety
clip.
* Caution : Prevent the power
cord from being pinched
between the wall mounting
bracket and the set when
installing the set.
(A pinched power cord may
cause an electrical short)
