LGIC CDMA Fixed Wireless Terminal
LST-200/2200
15
4
4
.
.
S
S
y
y
s
s
t
t
e
e
m
m
F
F
e
e
a
a
t
t
u
u
r
r
e
e
s
s
Hookflash
When the terminal receives a hookflash from the connected telephone device, it will
automatically allow:
1. For producing dial tone again after a phone number has been dialed without connection.
2. The use of special cellular services which may be available in your cellular service area.
Note:
Hookflash is accomplished in a call through either pressing the dedicated hookflash
key which is available on some phones or through a rapid single press of the hang-up
mechanism upon which the handset rests when the phone is hung up.
Dial Time
When placing a call, the phone number is sent over the network after last digit is dialed. In
order to insure adequate time for dialing the last digit, a delay of 5 seconds is programmed
into the terminal.
ROH (Receiver Off Hook)
If the telephone equipment remains “off-hook”, meaning that the handset is left off of its cradle
as it would be when you hang up, with no dialing activity for about 45 seconds, a ROH tone
emits from the receiver for a period of 60 seconds.
Special Cellular Services
Many cellular systems offer special services such as call waiting, call forwarding, etc. You can
purchase these services from your cellular service provider. There are certain dialing
sequences to be entered, which vary from service provider to service provider. The service
provider will provide the dialing instructions for your system.
Call Forwarding
– An incoming call can be delivered to another telephone number
programmed. Please contact your cellular service provider to use this feature.
Call Waiting
– You can receive another incoming call during a call. In this case, you will hear
beep tone and then you can connect the second call holding the first call by entering a code
required by cellular service provider. Your cellular service provider may require hookflashing
(a quick, simulated "hang up") to answer the waiting call. Other providers may require
entering the codes involving digits 1-9, *, and # to answer a waiting call.
Three-way Conference Calls
- For three-way conference calls, a hookflash transmits the
SEND command. Please contact your cellular service provider for more information on using
this service.
F
Example
¨ ç
Dial the first number and wait until connected;
¨ è
When connected, give hookflash and dial the second number and give one more hookflash to
be connected;
¨ é
When the second call is connected, give hook flash to complete a 3-way conference call.
