LG LRSPC2051AB, Service Manual

Page: 63 / 122

2-4. Ice Ejection Control Function
1. This is to eject ice from icemaker cube mould after icemaking is completed.
2. If Hall IC signal is on within 3.6 seconds after ice ejection motor rotates in normal direction, it does not proceed ice
ejection but waits. If the ice bin is full, ice ejection motor rotates in normal direction in every hour to check the condition of
ice bin. If the ice bin is not full, the water supply control starts after completion of ice ejection control. If the ice bin is full,
ice ejection motor rotates in reverse direction and stops under icemaking or waiting conditions.
3. If ice bin is not full, ice ejection starts. The cube mould tilts to the maximum and ice is separated from the mould and ice
checking lever raises.
4. Ice ejection motor stops for 1 second if Hall IC signal changes from OFF (low) to ON (high) after 3.6 seconds when ice
ejection motor rotates in normal direction. If there is no change in Hall IC signals within 1 minute after ice ejection motor
operates, ice ejection motor stops as ice ejection motor or hall IC is out of order.
5. If ice ejection motor or Hall IC is abnormal, ice ejection motor rotates in normal direction to exercise initial operation. It
resets the icemaker if ice ejection motor or Hall IC is normal.
6. The mould stops for 1 second at maximum tilted conditions.
7. The mould returns to horizontal conditions as ice ejection motor rotates in reverse direction.
8. When the mould becomes horizontal, the cycle starts to repeat:
Water Supply
→
Icemaking
→
Ice Ejection
→
Mould Returns to Horizontal
ICEMAKER AND DISPENSER OPERATION PRINCIPLE AND REPAIR METHOD
- 63 -
Bin is
not full
HALL IC
OUTPUT
SIGNALS
Bin is
full
HALL IC
OUTPUT
SIGNALS
ICE CHECKING
AXIS
ICE CHECKING LEVEL 30
°
Maximum tilting
point
Icemaking
(Original point)
Lock
2
±
1 sec
9
±
3 sec
8
±
3 sec
Ice Checking Ice Ejection Lock
Horizontal
Conditions
Level Retrun
Conditions
<Timing Chart During Ice Ejection>