14
Room Air Conditioner
Control Locations
Electronic Controls
POWER
MODE
-
Push this button to cycle through the modes from
COOL FAN HEAT COOL.
- COOL
• Fan runs continually for normal cooling operation.
- ENERGY SAVER
• The fan stops when the compressor stops cooling & heating
operations. Approximately every 3 minutes the fan will turn on and
the unit will check the room air temperature to determine if co
oling
& heating is needed.
• For Energy saver operation Dip switch #2 is ON position. Refe
r
Dipswitch setting at P.No 16
- FAN
• Fan operation without heating or cooling.
- HEAT
• Fan runs continually for normal heating operation.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until sh
ut-off.
• For your sleeping comfort, once Time is set, the setting temperature will raise 2°F after 30 minutes, and once again
after another 30 minutes.
• Push Timer to cycle through the settings from 1 Hour 2 Hours
...
12 Hours maximum.
FAN SPEED
• Every time you push this button, it cycles through the settings as follows:
{High(F2) Low(F1) High(F2)}
• To turn ON the air conditioner, push this button.
To turn OFF the air conditioner, push this button
again.
• This button takes priority over any other button.
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of
54°F (12°C) to 86°F (30°C) by increments of
1°F (0.5°C).
• The setting temperature in the display.
°F
