51
MAINTENANCE
ENGLISH
%
Rotate the water filter up into position and
close the cover. The cover will click when
closed correctly.
3
After the water filter is replaced,
dispense 2.5 gallons of water (flush for
approximately 5 minutes) to remove
trapped air and contaminants from the
system. Do not dispense the entire 2.5
gallon amount continuously. Depress and
release the dispenser pad for cycles of 30
seconds ON and 60 seconds OFF.
NOTE
%
To purchase a replacement water filter:
Visit your local dealer or distributor
Web: Find Parts & Accessories from
Support section of lg.com
Call : 1-877-714-7486 (USA)
1-888-542-2623 (Canada)
%
Part number of the replacement water
filter: MDJ64844601(LT1000P)
1
Remove the old water filter.
Lower or remove
the top left shelf to
allow the water filter
to rotate all the way
down.
Press the push button
to open the water
filter cover.
%
Make sure to rotate the filter down
completely before pulling it out of the
manifold hole.
%
Pull the water
filter downward
and turn it
counter-
clockwise.
2
Replace with a new water filter.
%
Take the new water
filter out of its
packing and remove
the protective cover
from the o-rings.
%
With the water filter
tabs in the horizontal
position, push the
new water filter into the
manifold hole and turn it
clockwise.
NOTE
%
Replacing the water filter causes a small
amount of water (around 1 oz. or 25 cc)
to drain. Place a cup under the front
end of the water filter cover to collect
any leaking water. Hold the water filter
upright, once it is removed, to prevent
any remaining water from spilling out of
the water filter.