ENGLISH
7
Preparing
NOTE
• Image shown may differ from your TV.
• Your TV’s OSD (On Screen Display) may differ slightly from that
shown in this manual.
• The available menus and options may differ from the input source
or product model that you are using.
• New features may be added to this TV in the future.
• The TV can be placed in standby mode in order to reduce the power
consumption. And the TV should be turned off if it will not be
watched for some time, as this will reduce energy consumption.
• The energy consumed during use can be significantly reduced if the
level of brightness of the picture is reduced, and this will reduce
the overall running cost.
• The items supplied with your product may vary depending on the
model.
• Product specifications or contents of this manual may be changed
without prior notice due to upgrade of product functions.
• For an optimal connection, HDMI cables and USB devices should
have bezels less than 10 mm thick and 18 mm width. Use an
extension cable that supports USB 2.0 if the USB cable or USB
memory stick does not fit into your TV’s USB port.
A
B
A
B
*A
<
=
10 mm
*B
<
=
18 mm
• Use a certified cable with the HDMI logo attached.
• If you do not use a certified HDMI cable, the screen may not display
or a connection error may occur. (Recommended HDMI cable types)
-
High-Speed HDMI
®
/
™
cable (3 m or less)
-
High-Speed HDMI
®
/
™
cable with Ethernet (3 m or less)
CAUTION
• Do not use any unapproved items to ensure the safety and product
life span.
• Any damage or injuries caused by using unapproved items are not
covered by the manufacturer’s warranty.
• Some models have a thin film attached on to the screen and this
must not be removed.
• When attaching the stand to the TV set, place the screen facing
down on a cushioned table or flat surface to protect the screen
from scratches.
• Make sure that the screws are inserted correctly and fastened
securely. (If they are not fastened securely enough, the TV may tilt
forward after being installed.) Do not use too much force and over
tighten the screws; otherwise screw may be damaged and not
tighten correctly.
Antenna isolator installation guide
(Depending on model)
Use this to install TV in a place where there is a voltage difference
between TV Set and GND of antenna signal.
• If there is a voltage difference between TV Set and GND of antenna
signal, the antenna contact might be heated and excessive heat
might cause an accident.
You can improve the safety when watching TV by efficiently removing
power voltage from TV antenna. It is recommended to mount the
isolator to the wall. If it cannot be mounted to the wall, mount it on the
TV. Avoid disconnecting the antenna Isolator after installation. Before
starting, be sure that the TV antenna is connected.
ANTENNA/
CABLE IN
Cable / Antenna
Wall
Isolator
or
Connect one end of the isolator to cable/antenna jack and the other to
TV set or set-top box.
“Equipment connected to the protective earthing of the building
installation through the mains connection or through other equipment
with a connection to protective earthing - and to a cable distribution
system using coaxial cable, may in some circumstances create a fire
hazard. Connection to a cable distribution system has therefore to be
provided through a device providing electrical isolation below a certain
frequency range (galvanic isolator, see EN 60728-11)”
When applying the RF Isolator, a slight loss of signal sensitivity can
occur.
