- 19 -
ERROR MESSAGE
POSSIBLE CAUSE
REMEDY
FOR ERROR OCCURRENCE
¥ The machine is inclined.
¥ The Inlet Valve is troubled.
¥ The Air Tube is kinked or blocked.
¥ The Controller is troubled.
¥ The Circuit of thermistor is troubled.
¥ Thermistor is troubled.
¥ The Controller is troubled.
¥ Repair the Circuit of thermistor.
¥ Replace the Thermistor.
¥ Repair or replace the Controller.
¥ Level the machine using adjustable
legs.
¥ Replace the Inlet Valve.
¥ Remove the cause of kink or block.
¥ Repair or replace the Controller.
Excessive water is sup-
plied than normal water
level.(Automatically drain
Pump operated.)
EXCESS ERROR
displayed
Condition
The resistance of ther-
mistor not normally out
put.
THERMAL ERROR
displayed
Condition
¥ The Circuit of Heater is troubled.
¥ The Thermistor is troubled.
¥ The Heater is shorted.
¥ The Relay Circuit is troubled.
¥ Repair the Circuit of Heater.
¥ Replace the Thermistor.
¥ Replace the Heater.
¥ Repair the Relay Circuit..
The water is not heated
or the temperature in
the Tub is overheated
to over 95¡
HEATER ERROR
displayed
Condition
- 18 -
8.TROUBLE SHOOTING METHODS
A. TROUBLE SHOOTING ACCORDING TO DISPLAYED ERROR MESSAGE
ERROR MESSAGE
POSSIBLE CAUSE
REMEDY
FOR ERROR OCCURRENCE
¥ The Water Tap is not opened.
¥ The Inlet Hose is kinked.
¥ The Filter of inlet valve clogged by
impure water.
¥ The Inlet Water Valve is normal ?
¥ The water pressure is very low.
( below 0.3 kgf/
)
¥ Inlet valve is blocked by safety
device for leakage sensing.
¥ The Filter clogged.
¥ The Drain Hose kinked or blocked.
¥ The Drain Pump/Motor or circuit is
troubled.
¥ Water leakage in Hose connections.
¥ Water is leaked by damages.
¥ Clean the Filter.
¥ Remove the cause of kink or block.
¥ Replace the Drain Pump/Motor or
repair the Circuit.
¥ Replace the connections of Hose.
¥ Check the point of damages and
repair or replace the related parts.
¥ Open the Water Tap.
¥ Repair the Inlet Hose.
¥ a) Close the Water Tap.
b) Unscrew the Inlet Hose (Inlet Valve side)
c) Clean the Filter of Inlet Valve.
¥ Replace or repair the Inlet Valve.
¥ Check the water remain on the base.
1) Check the point of damages and
repair or replace the related parts.
2) Disconnect the inlet hose to
dishwasher to unlock the safety valve.
Not reached to the nor-
mal water level in spite
of 10 min. water supply
INLET ERROR
displayed
Condition
Not fully drained out in
spite of 5 min. drain
operation
The water level in Tub
goes down during
operation
DRAIN ERROR
displayed
Condition
LEAKAGE ERROR
displayed
Condition
