Unit:mm
Step 1 :
PREPARE CUPBOARD OPENING
Step 2 :
PREPARE ELECTRICAL WIRING
1
2
3
This appliance must be supplied with
correct rating voltage and hertz as shown
on instruction manual, and connected to
an individual, properly grounded branch
circuit, protected by minimum 13 amp
circuit breaker or time delay fuse.
Wiring must be 2 wires with ground.
The power plug must be in a accessible
location adjacent to and not behind the
dishwasher and within 1.2 meters of the
dishwasher side.(See page 7 Fig.A)
The power plug must be correctly
earthed, if in doubt, have it checked by a
qualified Electrician. No other appliance
should be connected to the same plug
outlet by a double adapter or similar
plug.
CAUTION
For personal safety, remove house fuse
or open circuit breaker before installation.
Do not use an extension cord or adapter
plug with this appliance. Electrical and
grounding connections must comply with
the national electrical code/provincial and
municipal code and/or other local codes.
If bare chipboard is adjacent to or above
the dishwasher, it should be sealed with a
waterproofing paint or sealant to prevent
swelling due to steam.
INSTALLATION INSTRUCTIONS
WARNING
Any electrical work required to install this
appliance should be carried out by a
qualified electrician or competent person.
Any plumbing work required to install this
appliance should be carried out by a
qualified plumber or competent person.
1
2
3
4
This dishwasher is designed to fit to the
size shown as below.
Select a location as close to sink as
possible for easy connections to water and
drain lines.
The dishwasher should not be installed
more than 3 meters from sink for proper
drainage.
If dishwasher is to be installed in a corner,
a minimum 5cm of space is required
between the washer and an adjacent
cabinet or a wall.
5
