■
When the drain hose is connected to a
separate stand pipe, it is essential that an
tight connection is made.
Refer to Fig.B
Drain Hose Extension
Extend Drain Hose as shown below.
Fig. A
Fig. B : Drainage connection - stand
pipe.
Step 5 :
DRAIN LINE CONNECTION
If the end of drain hose does not fit to the
drain line, use a piece of rubber
connector(not supplied) that must be
resistant to heat and detergent and may be
obtained from a plumbing shop.
There are 2 typical connections as shown in
Figure A, B.
The “S” trap spigot must be drilled out cleanly
and free of obstruction to its maximum internal
diameter, if used for drainage.
To prevent siphoning, one of the following
instruction methods must be followed:
■
When the drain hose is connected to a sink
“s” trap or waste disposal unit, the hose must
be looped up to the underside of the bench
top and secured.
INSTALLATION INSTRUCTION
1
2
CAUTION
When you connect or extend Drain Hose,
make sure that drain hose is not kinked.
(Bends should have 40 mm radius.)
7
