LG LCRM1240SB, Service Manual

Page: 14 / 41

9. DISASSEMBLY INSTRUCTIONS
IMPORTANT NOTES:
UNIT MUST BE DISCONNECTED FROM ELECTRICAL
OUTLET WHEN MAKING REPAIRS, RE-PLACEMENTS,
ADJUSTMENTS AND CONTINUITY CHECKS. WAIT AT
LEAST ONE MINUTE, UNTIL THE HIGH VOLTAGE
CAPACITOR IN THE HIGH VOLTAGE POWER
SUPPLY HAS FULLY DISCHARGED. THE CAPACITOR
SHOULD BE DISCHARGED BY USING INSULATED
WIRE - I.E. TEST PROBE CONNECTED TO 10KOHM
RESISTOR IN SERIES TO GROUND. WHEN
RECONNECTING THE WIRE LEADS TO ANY PART,
MAKE SURE THE WIRING CONNECTIONS AND LEAD
COLORS ARE CORRECTLY MATCHED ACCORDING
TO THE OVERALL CIRCUIT DIAGRAM. (ESPECIALLY
SWITCHES ANDHIGH VOLTAGE CIRCUIT.)
A. REMOVING OUT CASE (Figures 7)
(1) Remove four screws from the rear section.
(2) Remove one screw from the side section.
(3) Push the outer case back about 1 inch (3cm).
(4) Lift the case from the set.
B. REMOVING COFFEE MAKER ASSEMBLY(Figure 8)
CAUTION: BE CAREFUL HOT SURFACE!
AFTER BREWING, ENTIRE WARNING PLATE
SURFACES ARE VERY HOT. BEFORE
SERVICING, COOL DOWN THE COFFEE
MAKER PARTS ENOUGH NOT TO GET
BURNT.
(1) Remove reservoir and carafe.
(2) Remove 2 screws, holding the coffee maker.
(3) Disconnect the 2 lead wires from connectors (CN3).
(4) Disconnect the heater wires from main leadwire.
(5) Lift up and pull out Coffee maker Assembly carefully
from the cavity.
Remove reservoir and carafe
Remove screw and remove upper case by pushing the hook.
Lift up and pull out coffee maker assembly case upper
-13-