7
A
A
If there is already an installation sleeve for the receiver unit
in the dashboard, it must be removed.
1
Remove the rear support from the unit.
2
Remove the control panel and trim ring from the unit.
3
Insert the lever
A
into the hole on one side of the unit.
Perform the same operation on the other side and pull
the unit out from the mounting sleeve.
5
4
3
1
2
6
Control panel
1
Slide the unit into the ISO-DIN frame.
2
Fit screws removed from the old unit.
3
Slide the unit and frame into the dash opening.
4
Install the dash panel or adapter plate.
5
Install the trim ring to the unit.
6
Install the control panel to the unit.
Removing the existing receiver unit
ISO-DIN Installation
Connection diagram
A
A
From antenna
B
B
To the wiring of the vehicle colors of leads.
• BLACK:
This lead is for the ground connection.
• ORANGE:
This lead is for the phone line connection.
• PINK:
This lead is for the dimmer line connection.
• RED:
This lead is for connection to the power supply terminal when the ignition
switch is set to ACC.
• YELLOW:
This lead is for connection to the battery (back-up) terminal from which
power is always supplied.
• BLUE:
This lead is for the power antenna connection.
• BLUE/WHITE:
This lead is for the remote amplifier on connection.
L
L
R
R
1
2
3
4
5
6
7
8
REAR
REAR
FRONT
FRONT
C
C
Speaker Connections
